Hi everyone. I am using an imageclass MF4350d with Windows 10. I noticed that there were two copies of this printer showing up on my computer, which was mildly annoying, and so I decided to uninstall and reinstall everything to try to fix that. However, when I do that, I now can't get the printer to work at all!
Specifically, I first installed the driver from the Canon website, which seemed to go just fine. But next I tried installing the toolbox (the file is ToolBox4911mf18WinEn and it is MF Toolbox 4.9), which doesn't work. I keep getting a message saying "Installation has been interrupted. The wizard was interrupted before MF Toolbox could be completely installed. To install the program at a later time, run Setup Wizard to perform the setup process again." I get the same result when trying to install the software directly from the CD I got when purchasing the printer.
Any suggestions?