I removed the print head and thoroughly flushed all ink following the instructions most often suggested until the water ran clear. Used distilled water only and was careful not to get anything wet that isn't supposed to get wet. Completely let the head dry out and replaced into the printer per instructions and ran several nozzel checks and even a few cleanings. On the printout all of the colors look solid except for the black ink which still has a faint band of white or a lighter shade of black and faint white lines running horizontally from end to end . Could this still be clogged black jets and the reason I'm still getting blue or cyan tints within certain black/dark gray areas in my b&w prints? Not getting any banding on prints though.
↧